Epoxy Countertops in Hesperia, CA

Walk into a kitchen in a lot of Hesperia homes built in the 1980s and 90s and you will find the same thing: tile countertops with grout lines that never come clean. We install epoxy countertops in Hesperia, CA that bury that tile, or tired laminate, under a smooth, seamless finish, poured in a sealed room so desert dust and big temperature swings do not ruin the cure.

(760) 488-6520

Get a Free Estimate

Tell us about the floor. Only your name and phone are required.

Form powered by splitforms

White epoxy countertop poured over old tile in Hesperia, CA

Covering tile without tearing it out

Ripping out a tiled counter is loud, dusty and often damages the cabinets underneath. Coating over it avoids all of that. The trick is getting a perfectly flat starting surface, because every grout line and chipped tile edge will telegraph through a thin coat. Our process for tile:

  1. Check every tile for looseness by tapping. Hollow tiles are reset or removed and filled.
  2. Grind down raised edges and clean decades of cooking grease from the grout.
  3. Fill grout lines and the gaps around bullnose edges with an epoxy filler, then sand the whole surface flat.
  4. Seal it with a primer coat so the tile and filler look like one uniform surface.
  5. Pour the color coat, work in any veining, and finish with a clear top.

Laminate tops get a simpler prep: repair any lifting seams, scuff the surface and prime. Either way, your cabinets, sink and backsplash stay where they are.

The High Desert makes resin work harder

Epoxy is chemistry, and the conditions in the room decide how it cures. Hesperia gives us three problems to manage.

Dust. Wind kicks up fine sand for days at a time, and it finds its way into houses through door gaps and swamp coolers. A single gust of grit landing on wet resin leaves specks that are locked in forever. We tent the work area in plastic, close the windows, ask that evaporative coolers be shut off during the pour and avoid scheduling on forecast wind days whenever we can.

Temperature swings. A house can drop twenty or thirty degrees overnight when the heat or air shuts off. Most countertop resins want a steady 70 to 80 degrees for the first day or two. Colder air slows cure and can leave a soft or cloudy surface, and very hot rooms shorten working time. We will ask you to keep the thermostat steady and may bring a small heater in winter.

Sun. At over 3,000 feet, the light coming through a south or west window is intense. UV slowly yellows epoxy, especially white and pale colors. Near a big window, we use a UV-resistant resin and may suggest a slightly warmer color that hides gradual shift.

Epoxy countertop curing under a dust tent in Hesperia, CA

Good places for an epoxy top

  • Kitchen runs and islands in tract homes from Main Street to Ranchero Road
  • Bathroom vanities with cracked cultured marble
  • Laundry and craft counters
  • Bar tops in game rooms and man caves
  • Workbenches in detached shops and RV garages out in Oak Hills and Summit Valley

We do not recommend epoxy for an outdoor barbecue island in full desert sun. UV and heat break it down quickly. Concrete, tile or stone are better outside.

How long until you can use the kitchen

Prep and the main pour usually take two days, with a third day for a second coat on more detailed designs. The surface is tack free in about a day. Light use, like setting down dishes, is fine after roughly three days. Give it close to a week before heavy use, and keep hot pans on trivets for the life of the counter, since epoxy can soften and mark under direct heat.

Care

Mild soap and a soft cloth are all it needs. Hard water from the tap can leave spots like it does on glass, so a quick dry after cleaning keeps the shine. Cut on boards, not on the counter. If the finish gets dull after years of use, it can be lightly sanded and recoated.

Cost

Tile tops take more prep than laminate, so they cost a bit more. Other factors are square footage, edges and backsplash coverage, and the complexity of the color design. Most homeowners spend much less than they would on new quartz with tear-out and cabinet repair.

Questions

Can you coat the tile backsplash too?

Yes, with a thicker gel resin that does not run on vertical surfaces.

Will it smell?

There is some odor during mixing and the first day of cure. We ventilate as much as the dust plan allows.

Do you coat garage floors on the same visit?

We can. See our garage floor epoxy and polyaspartic coating pages.

Done scrubbing grout?

Call (760) 488-6520 and we will check your counters, show you samples and quote the job in writing.