A climate that is hard on concrete
Hesperia is a cold desert, not a hot one in the way Palm Springs is. NOAA normals for the city show about 108 days a year at 90 degrees or higher, with 26 of them past 100, and also around 32 nights a year at or below freezing, most of them in December and January. A driveway here might be 60 degrees at noon in winter and frozen solid by dawn. Over years, those swings open cracks and loosen the surface. Strong sun bleaches the slab, and the wind that sweeps the High Desert carries sand that slowly scours it.
A coating does not change the weather, but it gives the concrete a tough, sealed skin. We use UV-stable polyaspartic and polyurea products that stay flexible in the cold and hold their color in the heat. Indoor epoxy has no place outside in this climate. It yellows within a season.
Big lots, long drives, lots of vehicles
Many Hesperia homes sit on half-acre or larger lots, often off roads that are still dirt or gravel. That means long driveways, wide parking aprons, RV pads and side yards for trailers, toy haulers and work trucks. Dirt tracked in from the road settles into the pores of bare concrete and turns it a dull brown. A textured coating keeps that dirt on the surface where a hose or leaf blower can move it. For drives that carry an RV or a loaded trailer, we build the coating thicker and suggest pads under jacks.
Because the drives are long, we can phase the job, doing the apron and the section nearest the garage one day and the run to the road the next, so you always have a way in and out.
Sand, wind and texture
Wind-blown sand is abrasive. On a smooth, glossy coating it leaves fine scratches and dulls the finish. That is why we use a satin clear topcoat with fine aggregate. It hides minor scuffs, gives traction when the drive is wet from the rare winter storm or a summer monsoon downpour, and still sweeps clean. On the north-facing parts of a drive that hold frost in the morning, the grit makes a real difference.
Our process
- Inspect. We look at cracks, settled sections and old sealers, and check how the drive sheds water during storms.
- Prep. Blowing, washing, degreasing and diamond grinding.
- Repairs. Cracks and pitted areas are filled and smoothed.
- Coat. Base coat, flake if chosen, then the textured topcoat.
- Cure. Foot traffic in hours, vehicles the next day.
We schedule around the wind. On days with strong gusts we postpone, since sand landing in wet coating ruins the finish. In summer we work early in the day, and in winter we wait for the slab to warm up before starting.
Colors that suit the desert
Sand, tan and warm gray blends hide dust between washes and look right against stucco and desert landscaping. Light colors also stay cooler under the summer sun. Dark solid colors look sharp for a week and then show every grain of dust, so we rarely recommend them out here.
Upkeep
Blow or sweep sand off regularly and rinse when convenient. Clean oil spots soon after they happen. Avoid metal snow shovels on the rare snowy morning. Plan on a fresh topcoat after several years to restore the sheen.
What a coating will not fix
Some older Hesperia drives were poured thin, without much base, directly on sandy desert soil. Over time those sections can sink near the edges or break around a heavy trailer spot. A coating will not hold broken pieces together. At the estimate we walk the full length of the drive, tap for hollow spots and mark any panels that should be replaced first. If the rest of the slab is sound, we can coat around a replaced section once it has cured, so the finished drive looks like one piece. We also check where water goes after a storm, because sheets of runoff and sand washing across the drive tell us where a little extra texture or a cleaner edge will help.
Questions
Can you coat the garage too?
Yes. See our garage floor epoxy for the inside.
Is a sealer cheaper?
Yes, and concrete sealing is a good choice if you only want protection without color.
Do you work nearby?
Yes, including Victorville, Apple Valley and Oak Hills.
Get a High Desert driveway quote
Call (760) 488-6520. We will measure the drive, check the concrete and give you a written price.